Unplug the small white internal connector from the circuit board. Snip the Pins:
Once you have completed your repair or replacement work, follow these precautions before cranking up the music:
Turn on the T3 and test the new volume control. Make sure it's working smoothly and the volume changes correctly. creative gigaworks t3 volume control replacement work
: Soldering iron and solder, small Phillips screwdriver, cutting pliers, and super glue. : Adjustable wrench and contact cleaner (like ) for minor cleaning before attempting a full replacement. Step-by-Step Replacement Guide Disassemble the Knob
The volume control potentiometer is a small electronic component with three legs. It's connected to the front panel of the subwoofer unit via a small wire harness. Unplug the small white internal connector from the
Pass-through ports for headphones and auxiliary input.
Would you like a wiring diagram for the DIY pod, or help finding a compatible 7-pin DIN connector? : Soldering iron and solder, small Phillips screwdriver,
Peel back the rubber anti-slip pad on the bottom of the volume pod to reveal the hidden screws.
Use a larger piece of heat shrink over the entire spliced section to provide strain relief so the internal wires do not pull apart during everyday use. Alternative Solutions
If your volume control pod (the "puck") is malfunctioning, you have three primary options: Potentiometer Replacement
Create a jumper connection between the to keep the amplifier awake.