Mount the manual collimator onto the tube port flange. Ensure the alignment pins seat correctly.
To avoid repeating the frequently, implement these practices:
1. Tube Stand Installation (Floor-to-Ceiling or Floor-Mounted)
Route the incoming 3-phase lines to the main terminal block inside the generator. drgem x ray service manual install
This article provides a general overview of the installation process based on official service documentation. 1. Pre-Installation and Site Preparation
Press all emergency stop buttons on the console, table, and tube stand to verify immediate power cut-off.
Wire the table and wall stand Bucky grid motors and cassette sensing trays to the generator interface board. 6. Software Configuration, Calibration, and Testing Mount the manual collimator onto the tube port flange
Ensure walls, doors, and control booth windows have adequate lead equivalence (e.g., 2mm Pb) as determined by a local radiation physicist.
Incorrect wiring can destroy sensitive digital components. Follow the system's schematic diagram carefully. High-Voltage (HV) Cables
: Configure the tube parameters within the service software. Automatic Calibration : Many DRGEM systems, like the GXR-S, feature automatic calibration like the GXR-S
The room must be shielded, and floor-mounting positions for tube stands must be reinforced. 2. Unpacking and Physical Inspection
Provide a copy of the room's radiation survey report to the facility's Radiation Safety Officer (RSO).
Alternatively, a feature where each part of the installation has a digital twin with schematics and torque specifications, ensuring that physical installation meets technical requirements. Or maybe a built-in checklist with pass/fail entries for each step, which can then be printed or digitally archived as part of the installation records.