Reset Verified: Evoko Liso Factory

WiFi credentials or static IP settings.

A: If the touch screen is unresponsive, you can force a power cycle by disconnecting the power source (PoE or power adapter) for a few seconds before reconnecting it.

Click . Once complete, the drive may appear as "Boot imx6dl" and might trigger Windows "format drive" errors— ignore these . Step 2: Execute the Factory Reset

The device cannot communicate with the Evoko Home server. evoko liso factory reset verified

Preparing the unit for a new room and different settings. ⚠️ Important Prerequisites Before starting, ensure you have the following: A USB Flash Drive: 2.0 or 3.0, formatted to FAT32 .

: Once the success message appears, remove the USB and powercycle the device. It will now be in an unconfigured state, ready to be "claimed" again in Evoko Home Biamp Cornerstone Expert Insight & Troubleshooting Reviewer Note Complexity

Let the device read the USB drive. The screen will display a flashing or updating status. Once complete, the device will automatically reboot into the initial setup wizard screen. Remove the USB drive. Method 2: The Software Reset (Via the On-Screen Admin Menu) WiFi credentials or static IP settings

If prompted for admin credentials, the default PIN is often .

Download the from the official Biamp/Evoko Downloads .

Download the latest Evoko Liso firmware (an .iso or .fw file depending on the version) from the official Evoko support portal. Once complete, the drive may appear as "Boot

: If the reset was successful, the default Admin PIN for the device is usually if it enters a demo or setup mode. Connection Issues : Ensure your server meets the minimum system requirements

Follow this sequential sequence to safely perform the hardware reset:

Locate the small rubber plug on the side/back of the Liso unit covering the MicroSD slot. Remove it.