Hanmatek Dos1102 Manual Jun 2026

The DOS1102 features a USB port on the front. You can save screenshots (BMP) or waveform data (CSV) directly to a flash drive for reports or further analysis on a PC. Math Functions:

If the square wave looks distorted (rounded corners or "overshoot" spikes), use the adjustment tool (included with the probe) to turn the trimmer capacitor on the probe connector until the wave is perfectly flat and square. 3. Key Functions for Daily Use Automatic Measurements:

Use the small plastic screwdriver included in your probe bag to gently turn the adjustment screw inside the probe head until the wave is perfectly flat.

The DOS1102 layout is designed for logical flow, divided into three main control sections: Vertical System: Controls the Y-axis. Here you adjust the hanmatek dos1102 manual

Change the vertical scale (zoom in or out vertically). The Horizontal Control Zone

If you encounter issues with your DOS1102, refer to the troubleshooting section in the manual. Common issues and their solutions include:

Whether you are trying to connect the scope to a or use it as a standalone unit. The DOS1102 features a USB port on the front

There is a mismatch between your probe and your oscilloscope software settings. Ensure that if the physical switch on the plastic probe body says 10X , your internal channel menu ( CH1 -> Probe ) is also set to 10X . Factory Reset / Self-Calibration

: Output terminal providing a 1kHz square wave for probe calibration. Control Knobs and Buttons

1 MΩ ± 2%, in parallel with 20 pF ± 3 pF Maximum Input Voltage: 400V (PK + DC, Peak) 2. Front Panel Layout and Control Definitions Here you adjust the Change the vertical scale

Too Much Compensation Correct Compensation Under-Compensated _______ _______ _______ / \ | | / | / \ | | / | ____/ \____ _____| |_____ ____/ |____ Use code with caution. Steps for Probe Compensation Connect the probe to .

Controls Time Base modes, such as Main, Window, and X-Y mode. 4.3 Trigger System Settings