is a specialized software utility designed for iOS technicians. Developed by PK3M, the tool extracts essential hardware identity data directly from an iOS device's logic board after a NAND replacement or during a critical breakdown.
Depending on the specific target hardware, HW Reader usually interfaces via standard serial connections, such as COM ports, USB-to-TTL adapters, or specific JTAG/UART interfaces.
Identifying the original MAC address for Wi-Fi and Bluetooth, which is often required when replacing a NAND chip or performing an iCloud bypass. iOS Support: Hw Reader By Pk3m V0.2 Download
The is a highly specialized repair utility designed for iOS technicians to retrieve critical hardware calibration data—including Serial Numbers (SrNm) , Wi-Fi MAC addresses (Mac) , and Bluetooth MAC addresses (Bmac) —directly from an Apple device's hard drive (NAND/HDD). This software is essential when a device's original hard drive fails or dies. Without this vital calibration information, a newly replaced NAND chip cannot be properly activated through Apple's official servers, effectively rendering the device useless.
Video overviews and legacy direct links can often be verified through trusted tech support channels like the PK3M Tool Hardware Reader Guide . is a specialized software utility designed for iOS
: Built-in "iDevice Panic Log Analyzer" to help identify the root cause of unexpected device reboots or hardware failures. System Requirements & Setup
To run the tool successfully, the following environment is typically required: : Windows 10 (64-bit). Identifying the original MAC address for Wi-Fi and
[Dead NAND Drive] ➔ [Solder New Blank NAND] ➔ [DFU Restore via iTunes/3uTools] ↓ [Write Info to NAND] [Read System Info via HW Reader] [Jailbreak via Checkra1n] ↓ [Final Restore & Normal Activation]
Extracting firmware or data dumps from chips.
