Jk 721 Cutting Plotter Driver ~upd~ ❲Updated – 2027❳

**Latency and Buffering

Change this from "File" or "USB" to the exact COM Port you found in the Device Manager (e.g., COM3).

There are two primary methods to set up your JK 721: using a dedicated driver or relying on your cutting software. jk 721 cutting plotter driver

:

: Managing registration mark detection for accurate print-and-cut tasks. Hardware Specifications **Latency and Buffering Change this from "File" or

Ensure you are using the official driver from the manufacturer, Jinan King Rabbit Technology .

In your cutting software (like SignCut, Flexi, or Artcut), look for , "JK Series" , or " Generic HPGL " . Port Configuration: Open Device Manager on your PC. Hardware Specifications Ensure you are using the official

: Go to Device Manager > Ports > Right-click your COM Port > Properties > Port Settings. Ensure Flow Control is set to Hardware . Consider switching to a shorter, shielded USB cable. COM Port Disappears or Changes Randomly

9600 (or 38400 depending on your specific board revision) Flow Control: Hardware (RTS/CTS) or Xon/Xoff Data Bits: 8 Parity: None Stop Bits: 1 Setting Up in Artcut Click on Cut/Plot to open the output window. Click Device and select Jinka -> JK721 . Go to Link To and choose the matching COM port.

Most Chinese-manufactured cutting plotters utilize the or CH341 USB-to-Serial chip. What it does: It creates a virtual COM port on your PC.