Jungheinrich Eje 120 Error Code 4372 Top Patched Online

When the main controller loses contact with this module, it enters a "Safe State." It assumes the operator cannot control speed or lifting, so it disables all hydraulic and drive functions.

: Jungheinrich has released firmware updates for the tiller head specifically to address this error. The update expands the "neutral window," making the system less sensitive to minor sensor fluctuations.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Discussion: Error 4372 - Forums - Forklift Action jungheinrich eje 120 error code 4372 top

[Isolate the Fault] ---> [Inspect Physical Connections] ---> [Check Voltage/Software]

Do you have access to a or software interface? Share public link When the main controller loses contact with this

If the error persists after a simple restart, consulting the official Jungheinrich Service Manual

Does the error pop up or only while handling loads ? This public link is valid for 7 days

The "Top" module refers to the electronics housed inside the tiller arm head—the handle you grip to steer. This module contains:

I can provide the specific wiring pinouts or manual calibration menu steps matching your exact setup. Share public link