Secure the operator using the provided hexagonal-headed screws and brackets Peiter Automatic Mechanical Stops Closing Stop
LPPR70-10P-EN-V4.2 Last updated: 2025
: In case of power failure, pull the cord connected to the mobile trolley. This allows the door to be moved by hand. To reconnect, move the door back to its initial position until it hooks back into the transmission. Programming (One-Touch) : Switch off the power supply.
air in system → repeat priming. If pump short‑cycles: check pressure tank pre‑charge (should be 0.2 bar below cut‑in).
Page 4. PR 70-07 INSTALLATION. CLOSING MECHANICAL STOP. DRIVE CARRIAGE. OPENING MECHANICAL STOP. PRC/PRB. PR 70-07. RELEASE LEVER. montaza.lv probo pr70 pr70-dl
Life Probo Technical Support Email: support@lifeprobo.com Tel: +1 (800) 555-PROBO (7762) Web: www.lifeprobo.com/support/pr70
Regular maintenance is crucial for the safe and reliable operation of your Life PROBO PR70.
Programming is managed via the control board (e.g., RG1 24P): montaza.lv Remote Control Identification:
: The PR70 is designed for approximately 50 work cycles and includes features to help you plan rebuilds around your schedule.
. The following guide summarizes the essential procedures for its installation, use, and maintenance based on the official Life Home Integration 1. Installation Procedures
: A minimum gap of 40 mm is strictly required between the highest point of the door's travel path and the ceiling. Mechanical Inspections
Uses a 230V AC 50 Hz supply with a pre-wired Schuko plug; the cable must not be altered.
Secure the operator using the provided hexagonal-headed screws and brackets Peiter Automatic Mechanical Stops Closing Stop
LPPR70-10P-EN-V4.2 Last updated: 2025
: In case of power failure, pull the cord connected to the mobile trolley. This allows the door to be moved by hand. To reconnect, move the door back to its initial position until it hooks back into the transmission. Programming (One-Touch) : Switch off the power supply.
air in system → repeat priming. If pump short‑cycles: check pressure tank pre‑charge (should be 0.2 bar below cut‑in).
Page 4. PR 70-07 INSTALLATION. CLOSING MECHANICAL STOP. DRIVE CARRIAGE. OPENING MECHANICAL STOP. PRC/PRB. PR 70-07. RELEASE LEVER. montaza.lv probo pr70 pr70-dl
Life Probo Technical Support Email: support@lifeprobo.com Tel: +1 (800) 555-PROBO (7762) Web: www.lifeprobo.com/support/pr70
Regular maintenance is crucial for the safe and reliable operation of your Life PROBO PR70.
Programming is managed via the control board (e.g., RG1 24P): montaza.lv Remote Control Identification:
: The PR70 is designed for approximately 50 work cycles and includes features to help you plan rebuilds around your schedule.
. The following guide summarizes the essential procedures for its installation, use, and maintenance based on the official Life Home Integration 1. Installation Procedures
: A minimum gap of 40 mm is strictly required between the highest point of the door's travel path and the ceiling. Mechanical Inspections
Uses a 230V AC 50 Hz supply with a pre-wired Schuko plug; the cable must not be altered.