Without the user manual, an error code on the Lovato 31 RGAM 12 is a mystery. Here are the most common codes from the manual:
Three-phase utility voltage, single-phase generator voltage, and battery health. Operating Modes: Off, Manual, Automatic, and Test. 🛠️ Installation and Wiring Diagram Guidelines
Connect the common terminal of the output relays to your control voltage source. Connect each individual step output (1 through 12) to the coil of the respective capacitor contactor (KM1 to KM12). 3. Programming and Configuration lovato 31 rgam 12 user manual
Tracks three-phase mains voltage.
When the controller detects an anomaly, it shuts down the engine or blocks transfer actions while displaying a fault status. Generator Fails to Start (Cranking Fault) Without the user manual, an error code on
The user interface of the RGAM controller is designed for intuitive operation, providing all the necessary controls and status indicators at a glance.
Connect the alternator output phases so the controller knows when the generator has reached the correct voltage and frequency. Control Outputs: Start: Connects to the starter motor relay. Fuel: Connects to the fuel stop-solenoid. To access the internal settings (thresholds
To access the internal settings (thresholds, timers, and delays), you must enter the programming mode. Common Adjustable Parameters:
Keep your controller in peak condition with these routine checks.
Use a dry cloth to keep the display legible.