Mori Seiki Ex Alarm List Here
Before opening electrical cabinets, check the obvious variables: Is the coolant tank full? Is the way-lube reservoir topped up? Are all safety doors completely closed and clear of chips?
I can provide targeted diagnostic steps and specific PMC parameters for your machine setup. Share public link
What is your machine's (e.g., NLX2500 with MAPPS, DuraTurn, SV-500)? What was the machine doing right when the alarm triggered?
Turret indexing and tool changing require precise mechanical and electrical synchronization.
Attempted cycle start without the chuck being properly clamped. DOOR NOT CLOSED The machine door is open, preventing cycle initiation. EX0069 DOOR LOCK CHECK TIME OVER
Open your Fanuc or Mitsubishi control screen to view current I/O bit states: Press the key. Select the PMC softkey, then choose DIAGNOSIS or STATUS .
The chip conveyor motor drew too much current, indicating a physical jam.
Turret alarms occur during index cycles, often due to mechanical jams or misaligned rotational sensors.
Here are a few examples of common alarms found on the Mori Seiki EX alarm list:
Check for mechanical jams or heavy chip buildup behind the turret disk. Verify hydraulic pressure to the turret clamp/unclamp manifold. Step-by-Step EX Alarm Troubleshooting Framework
: The system did not receive a "door locked" confirmation signal within the expected timeframe.
Before opening electrical cabinets, check the obvious variables: Is the coolant tank full? Is the way-lube reservoir topped up? Are all safety doors completely closed and clear of chips?
I can provide targeted diagnostic steps and specific PMC parameters for your machine setup. Share public link
What is your machine's (e.g., NLX2500 with MAPPS, DuraTurn, SV-500)? What was the machine doing right when the alarm triggered?
Turret indexing and tool changing require precise mechanical and electrical synchronization.
Attempted cycle start without the chuck being properly clamped. DOOR NOT CLOSED The machine door is open, preventing cycle initiation. EX0069 DOOR LOCK CHECK TIME OVER
Open your Fanuc or Mitsubishi control screen to view current I/O bit states: Press the key. Select the PMC softkey, then choose DIAGNOSIS or STATUS .
The chip conveyor motor drew too much current, indicating a physical jam.
Turret alarms occur during index cycles, often due to mechanical jams or misaligned rotational sensors.
Here are a few examples of common alarms found on the Mori Seiki EX alarm list:
Check for mechanical jams or heavy chip buildup behind the turret disk. Verify hydraulic pressure to the turret clamp/unclamp manifold. Step-by-Step EX Alarm Troubleshooting Framework
: The system did not receive a "door locked" confirmation signal within the expected timeframe.