Ensure the external DC circuit breaker is switched to the position.
Find the dual-hole grounding pad located on the rear or side panel of the chassis.
: Connect the dedicated Ethernet management port to your Out-of-Band (OOB) management network. : The system typically boots from an internal 80GB SSD Alcatel-Lucent Enterprise 5. Perform Initial Software Boot
Strip the insulation on the DC power cables back approximately 1/2 inch.
network operating system, though some models also support community SONiC.
Connect the opposite end of the grounding wire to the central data center earth ground bar. Section 5: Power and Fan Module Installation
Grounding cable (typically 6 AWG copper wire) and dual-hole grounding lug. Unboxing and Hardware Inspection
Locate the dual-hole grounding pad on the rear or side of the chassis.