Samsung M017f Isp Pinout Jun 2026

Powers the input/output (I/O) signaling interface.

| Signal | Location on PCB (SM-G017F) | | :--- | :--- | | | Resistor R310 | | CLK | Resistor R311 | | DAT0 | Resistor R312 | | VCC | Capacitor C500 (positive side) | | GND | Shield or capacitor C500 (negative side) |

Samsung Galaxy M01 Core (SM-M017F) ISP Pinout Guide for EMCC Direct Repair

Open your software (e.g., EasyJtag Plus or UFI Android ToolBox), set the bus width to samsung m017f isp pinout

Allows reading, writing, and erasing specific partitions (Boot 1, Boot 2, User Data).

Omit soldering VCC and VCCQ. Solder only CLK, CMD, DAT0, and GND. Insert a standard Micro-USB cable connected to a computer or 5V charger into the phone during the operation to provide the necessary voltages. Tools Required for the Procedure

Set the bus width to (ISP connections only support 1-bit mode). Powers the input/output (I/O) signaling interface

Supply power (via VCC/VCCQ jumpers or by plugging in a USB cable). Click or Check Device .

Tin the pads with a tiny bit of flux and solder your enameled jumpers. Connect the other ends of the wires to your eMMC box's ISP adapter board.

Wipe user data partitions safely if standard recovery menus are inaccessible. Safety Guidelines and Troubleshooting Solder only CLK, CMD, DAT0, and GND

After reverse-engineering the PCB and testing with multiple UFI, Easy JTAG, and Medusa boxes, the verified ISP pinout for is as follows:

| eMMC Adapter Pin | Connect to SM-G017F ISP Point | |-----------------|-------------------------------| | 3.3V (VCC) | VCC test point | | GND | GND | | CMD | CMD test point | | CLK | CLK test point | | DAT0 | DAT0 test point |

Technical Specifications of the Samsung Galaxy M01s (SM-M017F)

EasyJtag Plus, UFI Box, Medusa Pro II, or MiPi Tester.