V2000-c Rfid Access Control User Manual Review

Rapid / Batch Adding of Cards (Without assigning specific IDs)

Swipe the first card, then swipe the second card, then the third, and so on sequentially. Press # when finished, then press * to exit. Deleting Users Enter programming mode. Press 2 . Swipe the card you want to delete. Press # , then press * . Method B: Deleting by User ID (Essential if card is lost) Enter programming mode. Press 2 . Enter the target User ID (e.g., 0005 ). Press # , then press * .

Indicator : The LED indicator will turn red or flash slowly, indicating successful entry.

Enter Programming Mode →right arrow Press 1 →right arrow Swipe the RFID card →right arrow Press * . Add Card User by Specific ID Slot: Enter Programming Mode →right arrow Press 1 →right arrow Enter 3-to-4 digit User ID →right arrow Swipe the card →right arrow Press * . Add PIN User: Enter Programming Mode →right arrow Press 1 →right arrow Enter 3-to-4 digit User ID →right arrow Enter 4-digit PIN →right arrow Press # . Deleting Users Delete User by Card: Enter Programming Mode →right arrow Press 2 →right arrow Swipe the card →right arrow Press # . Delete User by ID Number: Enter Programming Mode →right arrow Press 2 →right arrow Enter User ID →right arrow Press # . Delete All Users: Enter Programming Mode →right arrow Press 2 →right arrow Press 0000 →right arrow Press # . Door Open Time Adjustment Set how long the lock stays unlocked after a valid entry. Enter Programming Mode. Press 4 + Time in Seconds (00–99) + # . V2000-c Rfid Access Control User Manual

involves proper physical mounting and exact wiring connection to an external power supply unit (PSU) and electric locking hardware. Mounting Instructions

The V2000-C RFID access control system is a cutting-edge security solution designed to provide efficient and secure access management for various applications, including offices, residential areas, and industrial sites. This user manual aims to provide a comprehensive guide for users to understand the features, installation, configuration, and operation of the V2000-C RFID access control system.

What (e.g., Maglock, electric strike) are you connecting? Are you integrating an external exit button or door sensor? Do you need assistance mapping out specific user slot IDs ? Share public link Rapid / Batch Adding of Cards (Without assigning

Valid card read, valid PIN entry, or successful keystroke.

Check your power supply output using a multimeter. Ensure the red wire is receiving a stable +12V DC current and the black wire is securely grounded.

Standard 125 kHz (EM or compatible ID cards/fobs). Reading Distance: 3 to 6 cm. Operating Voltage: 12V DC ± 10%. Current Draw: < 60mA. Lock Output Load: Max 3A. Bell Output Load: Max 50mA. Press 2

A: Check the J1 relay jumper settings (Part III). Ensure the jumper is set to NO if you are using an electric strike lock that requires a momentary closed circuit.

Adjust how long the door remains unlocked after a valid credential swipe. Enter Programming Mode. Press 4 .