Xnx Universal Transmitter Quick Start Guide ~repack~ -

Before handling the equipment, ensure strict compliance with local safety regulations and plant procedures.

Never open the enclosure while the unit is energized in a hazardous location.

Apply zero gas (or ambient air if completely free of target and background gases) to the sensor via the calibration cup. Xnx Universal Transmitter Quick Start Guide

🔁 For HART: use OUT & V-. 📡 For Modbus: connect A/B and set address via display or software.

Ensure at least 6 inches (150 mm) of clearance below the sensor for easy replacement and calibration adapter attachment. 3. Electrical Wiring and Connections Before handling the equipment, ensure strict compliance with

The XNX supports three primary sensor technologies: Electrochemical (EC), Infrared (IR), and Catalytic Bead (mV).

Distance requirements depend on wire gauge, power supply voltage, and whether transmitters are daisy‑chained. Always verify voltage at the transmitter terminals—it must remain within the specified range under all operating conditions. 🔁 For HART: use OUT & V-

Before you begin the installation process, it's crucial to inspect the device for any damage or defects. Here's a step-by-step guide to unpacking and inspecting your Xnx Universal Transmitter:

Use the mounting template (provided in the box) to mark holes.

Calibration is critical for accuracy. Ensure you have the correct calibration gas and a regulator.

What is installed? (Standard 4-20mA, HART, Modbus, or Foundation Fieldbus?)